Gregory, however we would not have a advised product in our products line that we recommend for the construction of your pool. - Chris Technological Companies
I have a patio with painted concrete. I am likely to extend and raise the concrete, putting concrete on top of the existing painted concrete. Do i have to do any type of prep for the painted concrete to guarantee bonding? - Eddy
The sides on my porch (concrete slab) have broken off due to incorrect installation on the railings. I am removing the railings and would want to increase 5 inches of concrete to reform them Which products could well be best? The new concrete would need to bond to the present concrete slab. That is a Do-it-yourself venture. - Danel
Don, however there isn't any real resolve for this. You are able to location and expansion joint material against the house and afterwards pour concrete to fill the hole.
I've a brick house while in the back again I've an enclosed patio. the cement slab is poured up towards the brick. I not long ago eliminated the brick from the house and I have a spot concerning the slab as well as house that's the width of a brick. (4 inches)Is there anyway I'm able to fill the hole and have it adhere towards the old cement slab? - Don Ratell
I've a 40+ year previous suspended slab in my garage. The concrete is spalled, uneven and stained with oil and other things mix concrete and plaster from most of the many years of abuse. I need to resurface it mainly because it collects water resulting from a doorway seal that will not seal due to the unevenness of the surface.
I've an present sloping slab. I desire to top the slab to get rid of the slope. What might be the minimum thickness of the topping within the high conclude of the present slab? -Michael - michael cather
Hi, I've water seeping into my garage under the garage door. I used to be thinking of pouring a concrete "dam" 2 inches high, 3 inches deep and also the width from the door to remedy this.
I've a foundation wall which is not flush with the wall sheathing. When we set up z-flashing, in some spots the z-flashing will stick out 1/2" earlier the concrete plus some locations, It's going to be flush.
I've a pool deck that has subsided absent from the pool coping as well as some relatively wide cracks. Can I use leading n bond to construct up deck to coping and fill and feather cracked places? address - Jeanette
Experienced a concrete company set a 1 one/two cap in living room recognize significant hollow spots. They informed me It is really standard and is not going to influence tile floor I'm finding ready to lay. Seems like I've a dilemma what ought to I do - Leon
Hello, I'm putting in limestone over a basement walk out set of stairs. The concrete do the job for that stairs was not performed corecctly so I could make even size riser mix concrete drill heights for the stairs. I corrected many of the stairs apart from the very best one which sits over the foundation wall and it is about 2 1/two inches much too small. So I want to lift it by about 2 inches then mortar my limestone to it.
Pat, you will have to use an epoxy to connect the rebar. We do not provide any epoxy type material. - Chris Complex Solutions
See ten more responses... Beth, regretably we don't manufacture a glue for your application. We advise calling a glue/adhesive manufacture for their tips. - Chris Technological Products and services